Need some router help.

MY new router is WRT110 by linksys, (Wireless N)


And theres no nat type feature?
my xbox spazzes out that the nat type isnt open.

Halp

[brentbizzle]

It's not a NAT problem, it's a blocked port. A router has to have NAT (network address translation). If it didn't, it wouldn't function!

A simple google of your problem brought this...

http://forums.linksysbycisco.com/linksy ... .id=121210

Open an Internet Explorer browser page.In the address bar type - 192.168.1.1
Leave username blank & in password use admin in lower case...

Click on "Applications and Gaming" tab and then click on "Port Range Forwarding" subtab...

1) On the first line in Application box type in Xbox, in the start box type in 88 and End box type in 88, leave the protocol as both and under ip address type in 192.168.1.20 and check the enable box...

2) On the second line in Application box type in Xbox1, in the start box type in 3074 and End box type in 3074, leave the protocol as both and under ip address type in 192.168.1.20 and check the enable box and click on Save Settings...

3) Once you return to the set up page click on the Security tab and uncheck Block Anonymous Internet Requests and click on Save Settings...

4) Click on set-up and change the MTU Size to 1452 and click Save Settings...

5) Now assign the given ip address on your Xbox

ip address :- 192.168.1.20, subnet mask :- 255.255.255.0, default gateway :- 192.168.1.1...

6) Also assign the dns addresses on the Xbox

Primary dns :- 4.2.2.2...Secondary dns :- 192.168.1.1

7) Turn off your modem, router, and Xbox...Wait for a minute...

Plug the modem power first, wait for another minute and plug the router power cable, wait another minute and turn the Xbox and test it...it will connect...

Basically you need a static address for your xbox, then setup port forwarding for it to allow packets to flow.

Thanks, fixed it.